Product
Description
The new NT2-A is a professional
large capsule (1 in.) condenser studio microphone with variable
pick-up pattern,variable high pass filter and variable pad.
These features provide greater creative control and versatility.
Three 3-position switches located on the mic body provide
the freedom to step from Figure 8, Cardioid or Omni polar
pick-up patterns; from a flat response to either 80 Hz or
40 Hz high-pass filter and a Pad adjustment of 0 dB, -5 dB
or -10 dB attenuation.
The heart of the NT2-A is the Australian designed and manufactured
TYPE HF1 dual diaphragm capsule. The frequency and transient
response of this new transducer has been voiced to complement
today s modern recording techniques,and yet still evoke the
silky smooth character of the legendary microphones of the
50's and 60's.The NT2-A includes a soft pouch and clip.
Features
The Australian designed and manufactured HF1 1 edge terminated,gold
sputtered, dual 5 um diaphragm capsule.
3-position variable polar pattern: Omni, Cardioid &Figure
8; all controlled on the mic.
3-position variable high-pass filter: Flat,80 Hz or 40 Hz.
3-position variable pad:0 dB,-5 dB or -10 dB.
Ultra low noise,transformerless SMT circuitry.
Wide dynamic range.
High strength heat-treated steel mesh head.
Durable satin nickel finish.
Internal capsule shock mounting.
Supplied complete with soft pouch and clip.
Technical
Description
Power
The NT2-A is designed to operate from phantom power to the
P48 standard.
The NT2-A will operate between 44V and 52V applied with positive
polarity to pin 2 and pin 3 of the output XLR connector.
Output Impedance
The NT2-A will operate satisfactorily into a load impedance
as low as 1K. If a load below this is used, the output signal
level will be reduced.
The NT2-A output is balanced between pin 2 (hot) and pin 3
(cold). Pin 1 is ground.
Specifications
Acoustic principle: Externally polarized 25 mm (1 in.) dual
diaphragm.
Directional pattern: Multi-pattern
Frequency range: 20 Hz - 20 000 Hz
Output impedance: 200
Signal /Noise ratio DIN/IEC 651: 87 dB (1 kHz rel 1 Paper
IEC651, IEC268-15)
Equivalent noise: 7 dBA SPL (per IEC651, IEC268-15)
Maximum SPL: 147 dB (@1%THD into 1k) 157 dB (@1%THD into 1k)
- pad at maximum
Sensitivity at 1 kHz into 1k: -36 dB re 1 Volt/Pascal (16
mV @94 dB SPL) +/- 2 dB
Maximum output voltage: +16 dBu (@1%THD into 1k)
Dynamic range of the mic amplifier: DIN/IEC 651 140 dB (per
IEC651, IEC268-15)
Power (Supply voltage): 48 Volts (P48)
Output Connection: 3 pin XLR,balanced output between pin 2
(+) and pin 3 (-). Pin 1 ground
Weight approx.: 860 grm (4.23 oz)
